Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm using the Cisco 897VA with the following (working) configuration...
controller VDSL 0 operating mode vdsl2
interface ATM0 no ip address shutdown no atm ilmi-keepalive
interface Ethernet0 no ip address!interface Ethernet0.3180 encap...
Hi, we have a customer site where the phones are intermittantly making a "pop" sound at the start of an incoming call and occasionally during calls too. Does anyone have any ideas about possible causes? We have tried rolling back handset firmware but...
HiI'm having issues with web browseing to cisco IP phones. Historically we could web browse to a a basic settings/ dianostics page of the phone by simiply browseing to the phones IP address. However after an upgrade to SCCP firmware 9.4.1.3 this is ...
I have a controller sat on a network (10.10.10.0/24) with a management address of 10.10.10.250. There's a distant site we have at the other side of the network with a range at 192.168.0.0/24. I have 5 thin HREAP access points on this network with t...
I have a test WLAN that I want to make domain users log onto with a domain user/pass but also force them to use the public key of a self-signed cert from the AAA server. At present I can get this to work, so for instance a windows client will connec...
In brief, what I am trying to find out is if the Cisco 897VAB is able to terminate two different VDSL connections, each with their own separate Layer 3 interface, without using the bonding (is this what Single-Wire mode means?).
This issue seems to arise when matching any vlan (match vlan 1-4094) on a class-map. It does possibly sound like a bug, but I've now ameneded my class-map to match all traffic based on protocol instead - this seems like it might work OK.
Class-ma...
I've now got a TAC case open, and the TAC engineer has managed to replicate the fault. I'm waiting to hear back. I've also attached the outputs here for information.
I started with a completely blank config, and applied the following to replicate t...
