Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we have an issue where any FXS port is staying up, after a remote caller hangs up. Debug does show a SIP BYE but the FXS port stays off-hook. Could this be a configuration issue?Many thanks,Kev
Hi,I'm trying to get the following working but I've been unsuccessful so far and wondered if its possible. Call flow I'm trying to achieve is below:DDI > AA with 3 options, then...1st and 2nd options are routed to external numbers, the 3rd option is ...
Hi,we are only seeing the protocols above being reported with nbar on an 877 dialer interface and atm0. Can't figure out why this is happening.#sh ip nbar prot Dialer1 Input Output ...
Hi, we're getting the above message on the WLC when trying to add another guest user. Authentication is locally using the WLC database. I understand there is a default 512 user (MAC?) limit and we're looking into changing that to 1024 (reboot will be...
Thank for the reply Alex. Unfortunately it's a DECT base station terminating on the FXS port and not a PBX, sorry should have mentioned!I'm wondering if it's just a limitation of the base station or if it's normal behaviour to leave the line open. Th...
Hi there,thanks for your reply I do actually have a dial-peer, tied in to the announcement script with 'service opt3'If I dial the pilot from a phone on the network I get the expected announcement...same goes for the 1st AA/queue script. The problem ...
Hi Rohit,Thanks for replying. The protocols are being recognized outbound ok and its specifically the rtp packets we're interested in to know why they aren't showing inbound to the device.Kev
Hi irisrios , this is CME not Callmanager. Only error is 'Version Error' in the logs when the phone registers andthe cnf is downloaded and firmware is compared.Thanks
