Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When CME is acted in SRST Mode Phone pickup MoH from local CME Router flash but in normal operation Phone pickup MoH from Call Manager.So i want in Normal Operation MoH file will be pickup from Local CME to avoid WAN Link utilization .I had alrea...
Hello Everyone,I am using cisco VPN client version 5.0.07.0290 for windows Xp and windows 7. windows xp clients are working fine while windows 7 client are able to connect but unable to access network.Not able to understand what is the problem with w...
We are not able to register CTI port & CTI Route point (created via CCX). We don't have idea about rm cm user also. Any configuration example will be appriacable for the same.Thanks
Hi All,I am facing problem with 7609S redudancy because of one of sup is not booting properly and getting error message in rommon mode,*** System received a Software forced crash ***signal= 0x17, code= 0x24, context= 0x4202cf84PC = 0x401adfb4, Cause ...
Hello @erazvi,Mostly campus LAN and WLAN guide are based on SD-Access ( Componetnts use: DNA, WLC 9800, ISE, Catalyst 9200/9300/9500). All the stuff are very much useful and provide all relevant information how to deploy using best practices.Commenda...
Hi,Thank you very much for your prompt response, But this is the the non bootable load which can upgrade existing installed vesion.While i require bootable load for new installation.Thanks
Hi,Can you please share me the download link for the same.Because I have already downloaded following from cisco site, but these are not bootable load.7.1.3.10000-117.1.3.10101-3Thanks
Hi,Same issue facing during installation CUMA 7.x.Could you please suggest me that from where I can download bootable load of suggested version or we have order again to cisco.Thanks
