Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a server with gbic of INTEL (AFBR-703SDZ-IN2).I need to connect this server to 6500 with gbic of Cisco (X2-10GB-SR)I didn't find information about the compatibility of these gbic...When I connect the server to 6500, I haven't link betwee...
hello!I have 6500 with this STP configuration:spanning-tree mode rapid-pvstno spanning-tree vlan 1-4094I need to enable STP on vlan 100 and vlan 103.When I do "spanning-tree vlan 100,103 root primary" and then "show spanning-tree".I see that STP is n...
Hello!I want to add module of WS-X6716-10GE(-3C). The type of 6500 isCisco WS-c6509-e (r7000) processor (revision 1.2).Can I add this module to this type of 6500?Do I need to reset the 6500 in order to the 6500 receive the module?Thanks...Sent from C...
hello,I need to apply an Reflexive ACL on switch 4500.I looking for IOS of 4500 switch that support in Reflexive ACL, and I dont found..There is an IOS of 4500 that support Reflexive ACL?What is?thanks...
Hello!I have a 3750 switch.The status of the switch is rommon," switch : ".there is not an IOS in the switch....Are there ways to install an IOS excepted xmodem???Thanks...Sent from Cisco Technical Support iPhone App
I want to show the status of the link. For example, when I disconnect port GigX/X from the switch. I want to see this in real time in terminal monitor.I want this information will be in the loggin...Thanks..
3. why I dont need to configure:switchport trunk encapsulation dot1qswitchport mode trunk4. If I have one switch , and the I want to creat int vlan (layer 3) without access port, it is possible?
