Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all. I have a site that is misbehaving and I would like to run my findings past the knowledgeable people of this forum. Here is the scenario:
Two 4400 WLCs in mobility group TEST~ 100 APs all running in local modeOne WLAN Profile15 different loca...
Hi AllI'm having a bit of a problem with some users finding that the MWI on their phone isn't lighting up when they have a voicemail. The users all seem to be limited to one particular partition/css. However, it has only stopped working in the last c...
Hey all, I'm afraid I'm quite new to Cisco VOIP so apologies if this is quite obvious.A user in a remote site has reported that, when anyone tries to ring a particular phone, their call gets forwarded to an unknown extension labelled "meeting room 2"...
I've got a bit of an odd BGP problem that I'm hoping someone might be able to advise on. I've attached a basic diagram to make it easier to describe the problem.Router A has a BGP session to ISP ARouter B has a BGP session to ISP BAll three routers h...
We have two locations with connections to two different ISPs which provides redundancy/failover should either connection go down. This works fine but I would also like to implement some kind of load balancing to shift some of the load from ISP A to I...
Good suggestion. As it turned out, the CSS for the unity ports did not include the partition with the phones. However, I have rectified this and it is still not working Do I need to restart anything to see the change?
Bingo! Checked the route plan report and immediately discovered the source of the problem. One of the staff at another site had created two users with the same extension (!?!) and left one outside of any route partition, causing the problem with the ...
