Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a problem when the users are presenting something on one TV, both the laptop and the TV are conected to the WLAN managed by a Cisco WLC 9800 but the problem is that fail very often, one moment everything is fine but after a few minutes o h...
Hi I have stack Switch with 3 Unit members with High CPU, according to the "show processes cpu" the proccess with more consumption are SISF Switcher Th and SISF Main Thread 426 38181448 7673019 4976 35.36% 29.17% 29.11% 0 SISF Switcher Th427 4935612...
HII`m trying to configure a WLAN with a simple captive portal with the internal Web Authentication Type but when th users try to connect the login page show an error and in the URL on the browser show https://1.1.1.1/login.html?redirect=www.msftcon...
HIHere is the thing, I need to add some FlexConnect AP of a remote Office to my WLC and I have to spread the same SSID that I use at my local office using local AP. I read some post and it says that the only option is to activate the option "FlexCon...
Hi
I have a Switch 6500 with a DC power fail, in the log it show the next error.
CAT6509_BAR#sh logg | inc powerAug 22 17:23:29: %C6KPWR-SP-2-PSFAIL: power supply 1 output failed.Aug 22 17:23:29: %C6KPWR-SP-4-PSREDUNDANTONESUPPLY: in power-redundanc...
Hi, after the reboot the virtual IP change but still when I try to connect he login page redirect to https://192.168.1.2/login.html?redirect=www.msftconnecttest.com/redirect and https://192.168.1.2/login.html?redirect=www.gstatic.com/generate_204
for this case you should use the match option in the route-map instead of set ip next-hop option, if you don´t the router do NAT with the wrong interface, which is the case, try the next modification. route-map NAT0 permit 10 match ip address 140 mat...
