Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I'll post what my take is, but can I get assistance with coming up with a basic BGP configuration for an ASR1001-X that meets these criteria?
*Two different providers with different ASN's.
*We have our own ARIN-assigned /24 block and ASN. Fo...
Hi all. We have a situation where we need to roll out a 3560CX as a L3 WAN switch for a small branch location. The WAN carrier requires that all traffic handed to it be marked with Dot1q tags and marked with CoS. The CoS tags have to be either 2, ...
Hi all. Seems like there are a lot of BGP discussions, but in my searches I have not seen any discussions that directly touch on the use case I have in mind.Scenario:I have an ARIN-assigned /24, a single ASR1001x, and two ISP's who are willing to us...
Hi there. We have 3 Nortel RG 9150 remote PBXs installed at a branch location, and they have been functioning well for years plugged into 3Com 4500 10/100 switches. These switches have a very basic configuration; nothing special. We are transit...
Thank you all so much for the input. Taking your changes and putting them all together, does this look workable?
interface GigabitEthernet0/0/0description Provider A - Prefer this connectionip address 1.1.1.1 255.255.255.0!interface GigabitEtherne...
Thank you for the input.
Does the snippet below accomplish the goals of controlling which way we advertise our netblock and influence which way our outbound traffic goes?
interface GigabitEthernet0/0/0description Provider A - Prefer this connectionip...
Joseph, as it stands, my solution works: the workstations mark with DSCP 0, and I can put them into CoS 2 (Premium tier), and the Cisco IP phones mark at DSCP EF, and that's already mapped to CoS 5 (Priority tier). But, I may need to put some credit...
Just for fun, I got into the http device manager and enabled "Recommended system setup" and then I set the port type to "Cisco Phone+Desktop", and that sets the parameters correctly too.
