Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone had any luck with creating a SIP Trunk between a UC320 and CUCM? We have a location that we recently just acquired that has a UC320 running on site and for simplistic and ease of transition it would be easier if we could just create a SIP...
Hello,I am trying to figure out a way to filter inbound routes. I want to allow almost all other routes in, except the
Default Route
That one needs to stay local to router itself. This connection is also connected via IPSec.The basic design of what...
I use to have a IKEv1 Connection between a Cisco 891F router and a Fortigate 200B. I changed that to IKEv2 configuration with no issues. I am now trying to configure an IPSEC tunnel between the Cisco 891F router and an 1841 router that can only sup...
So i have a weird entry in my routing table that I cant figure out. The one thing I do know is that its not supposed to be there. Its a router off a router using the same protocol as the upstream router, BGP. Ping and everything works, but its ca...
Long story short. I bought I a used cisco 2801 mainly for a lab/information purposes. I have lots of newer 2901s, but I wanted to step back a generation and see the differences between them. The odd thing is, the IOS that is loaded on the router c...
I agree. That is why I mothballed our 5506 back in 2018 and went with an alternative vendor. Even the ISR line of routers can either do a pool or a reservation in or out of the DHCP pool range.
Hi panos, In your last update you have a mismatch in the static routes and the interface on the Tunnel. is that intended? Also, you have to have an incoming and outgoing rule on the Fortigate for it to work properly. A weird glitch that I have se...
Hi Richard, For this VPN he is not using a Crypto Map, he is using a tunnel interface so he shouldn't have to deny that specifically since the traffic will be going through the non-NAT interface of Tunnel10. Here is my tunnel setup, and as you can ...
For your transform set, change the mode to tunnel. crypto ipsec transform-set FG200B esp-aes 256 esp-sha256-hmac mode tunnel On your dialer0 interface, do you have an inbound access list? If so, you need to also make sure to allow esp inbound from ...
Can you post the actual configurations, but sanitized. Its really hard to figure out what the issue might be with the limited configuration information that you posted. David
