Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to deploy our VPN configuration via REST API on ASR1001X, but I am currently testing it on CSR1000V in my lab. However, I am stuck with the problem that our VPN configuration is VRF-aware - meaning we do have transport VRF (FVRF) a...
Hello,does Cisco implement some OID to get traffic engineering (te) metric of the link when using MPLS TE? I need actually to write this parameter over SNMP so i need to find an OID through which i get/set this parameter of link. I was looking for it...
Hello,i have list of IP addresses of interfaces of router. I need to get the corresponding interface names (e.g. fa0/0) so that i can match them with the list of ip addresses (e.g. i have ip 192.168.1.1 and i need to find out that it is IP of fa0/0)....
Hello,i am programming and application and i already have list of IP addresses of interfaces of all routers in topology (via OSPF). Now i need to map these addresses to names of interfaces on each router (e.g. i have 192.168.1.1 on R1 and i need to k...
That is because the way one way delay is measured. You can check on cisco sites (i do not have nay link right now) and you will understand why the clocks has to be in precise sync in order to calculate any values for one way delay. Millisecond precis...
Well, it did not. I have found out that the problem was in time synchronization. If you want to measure one way delay, NTP has to be set up to synchronize clock between routers (jitter can work without it). The more accurately you want to measure del...
This solution does not work. When i configure clock-tolerance to any number it is still the same result: Number of latency samples = 0. And about the second solution - how am i supposed to bring 2 routers closer to sync when they are connected direct...
Is there any solution for this problem? I have exactly the same one - routers are synced with NTP server, i am in lab environment, NTP server is max 3 hops away from client using Ethernet connection. IP SLA probe is crossing max 5 hops. I am botherin...
