Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,I've been scouring Cisco.com and Google looking for documents relating to configuring the Interframe Gap/Interpacket Gap (IPG) and I can only find one document that describes how to change it, except for it's specific to a 6000 series switc...
I've been poking around in a few test routers trying to find where BGP states how long a route has been known from a neighbor. Based on Cisco's BGP path selection article: http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13753...
If I run the following command on a 6500 series switch:sh platform hardware capacity fabricI get the following output:Switch Fabric Resources Bus utilization: current: 0%, peak was 24% at 07:25:01 PDT Tue Aug 6 2013 Fabric utilization: Ingress ...
I'm trying to select the correct cable to connect to a Cisco Nexus 40G-FET (on a Nexus 6004). I've seen on Cisco's website that says the FET transceiver has 12 fibers in it. Yet when breaking this out to connect to four 10G FETs on a FEX (2232TM-E), ...
I thought I'd put a follow-up to my original question in case someone in the future is looking for more information on this. I was originally looking for information on this topic because my organization has been having throughput issues with one of ...
I'm not sure I completely understand your intent, but I'm also not sure you completely understand the function of the native VLAN. You perhaps do. But just in case: The native VLAN function on a dot1q trunk means that any frame coming from the native...
That's getting sidetracked. My issue isn't path selection manipulation. I can configure BGP to choose whatever path I want it to choose.Cisco routers choose BGP routes based on a certain set of criteria that we call attributes. I can see all of the a...
