Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to support wired mDNS across sites?Scenario is as follows:Hub site hosts the 5508 that services the hub site and 2 spoke sites separated by L3 routing.The hub site contains the wireless subnets (Layer 2 trunk).Hub site has wired Apple ...
Is it possible to have to site to site vpn connections to remote sites that have the same inside lan ip address space?Site A - 10.102.0.0/16Site B - 10.5.1.0/24Site C - 10.5.1.0/24 Both site B and C need to connect to site A.
Below is my intent, but I read somewhere that, "The port channel cannot span chassis which means that in order for that EtherChannel to work, they need to be going to the same location and you are not able to split up the EtherChannel".Is this possib...
I have 3x 2960S switches that need to be stacked.Two (2) are running 12.2(55)SE5 and are already stacked.I need to add a newer switch running 15.2(1)E.Can the switch running 15.2(1)E be downgraded to 12.2(55)SE5?All other switches at the site are run...
I think I found my answer. Has anyone actually done this?mDNS APThe mDNS AP feature allows the controller to have visibility of wired service providers that are on VLANs that are not visible to thecontroller. You can configure any AP as an mDNS AP a...
Well, I asked because the source of that statement was not that long ago and was in reference to 3750 switches:https://supportforums.cisco.com/document/10251/how-configure-cross-stack-etherchannel-cisco-catalyst-3750-switchesLogically, I think my pro...
