Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team, Good morning...Hope you all are safe I am in the middle of implementation and i have some doubt with the below scenario. I read about on ISG (Intelligent Services Gateway) on Cisco but not sure whether it should be use or it will work wi...
Hello Team,
I have recently got an vulnerability error on an ACS server inspite of proper certificate being applied.
Pls find the attached file which show the vulnerability error
Pls let me know how to resolve this issue.
Thanks in advance
Regards,...
Dear Team,
Customer had a concern that he want do upgrade the L3 device with minimum downtime.
Current version running is 12.2 and upgrading to new version 15.0.2.
He is concern of zero downtime with respect to access Switch.
He has 2960 sw at a acce...
Dear Team,
Customer had a concern that he want do upgrade the L3 device with minimum downtime.
Current version running is 12.2 and upgrading to new version 15.0.2.
He is concern of zero downtime with respect to access Switch.
He has 2960 sw at a acce...
Hello Team,Good Day!!!!!We have 5508 controller with the IOS version 8.0.115.0.I have been reported by the end users that they are getting disconnected from the wireless. and this is happening on the random basis.this issue is reported only 1-2 times...
Yes I already told him but the problem is customer dont have a down time of 30 mins. He is ready to give a max of 5-10 min.
that where the problem is...
Is there any other way like rebooting the slave just before stackwise protocol initiation happen ...
I have recently upgraded other devices with the same model it took me 30-40 mins to upgrade and join the stack back.
So planning to do this way.
Regards,
Vikas.
Hello Philip,
Thanks for your immediate response.
I am planning to do so..pls let me know whether it is possible.
We can disable the stack ports break the stack, boot the master, then after master comes up then we will boot the slave and later again ...
Hi,I had to raise an RMA for the device..Cisco TAC has recommended to do so...But I think there must be a other solution to resolve this issue...Can some1 provide me some other solution to it. Regards,Vikas
