Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We had a 3850 series stack before, but we made the switches standalone later. The command "no switch xxx provision" was used and it was successful but when we do "sh switch", it shows :
Switch# Role Mac Address Priority Version State----------...
Hello,
I have a WLC 5520 with the software version 8.3.102.0 having a mobility anchor as 5508 WLC Controller in another location running with a software version 8.0.140.0. The 5508 is also configured as Internal DHCP Server providing DHCP Addresses ...
Hello all,Heard that Cisco has announced the end of life for 1262 series Access points. Can anyone suggest the best replacement for this series of Access Points..
You may use a hub or a small switch if you directly want to go from A to B..If you want to use bigger switches, you may have to configure the ports in the same VLAN. You just need to configure the IP addresses in the same subnet ,the switch will lear...
Configure "ether channels" on both the sides of the L3 switch. You can enable IP routing on L3 and configure relevant SVi Interfaces on L3 for inter vlan routing. Using Ether channels, even if one interface is down, the ether channel shall remain up ...
Perhaps you can configure ports 20,21,22,23 as switchports and then put these ports on the relevant vlan(eg. vlan 14). You can enable "ip routing " on the switch and the put a default route as the next hop of the internet interface ip address( eg. if...
