Hi, I have configured a cross-stack etherchannel in a Cisco 3850; ports get added to the port-channel but one port always get suspended. If I try to add one when i add the other it gets suspended; if i change the order in which I add the ports to the...
Hi folks,
i have a VPN to our corporate LAN, which uses Anyconnect client. Since we deployed ISE in our LAN, we are not able to use remote desktop in our VPN.
Users can connect the VPN. can even ping the remote hosts, but can´t use remote desktop.
...
Hi folks, I have the following topology;IP Phones--->Call Manager--->Cisco CUBE--->Firewall ASA--->Internet<---VOIP ISP. We want to establish a SIP Trunk between the CUBE and the VOIP ISP. We already managed to register with the ISP, but we can´t est...
Hi everyone,Is it possible to use multiple gateways, in my case two, in a cisco cucm h323 environment?I have the task of adding 6 bri lines to my central site and I only have one gateway, so i want to add another one, but i have doubts if this is pos...
Please check the attached drawing. The goal is on the Cisco 3850 bundle the interfaces Gi1/1/1 and Gi2/1/1. And on the 6880 bundle the Gi1/5/1 and Gi2/5/1. I've already tried your suggestion, but with the same behavior.
Sorry but what is the logging level to see LACP messages? I've configured "logging buffered warnings" but that doesn't show LACP messages.I'm using LACP; i've tried to use ON mode, but what is happening is that traffic is only being forwarded out of ...
Yes i believe the correct term is EAP-Chaining. But i´m using EAP-TLS, a document i found states that EAP Chaining must be used with EAP-FAST.
AnyConnect version is 4.3.02039
AnyConnect gives me the ability to manage the mobile broadband network at...
