Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Cisco Nexus running the old version exposed to security vulnerability. Planning to upgrade it to newer version.Current version 5.2(1)N1(4)Target version 7.3(7)N1(1b) I went through below URL, but couldn't make the right upgrade path and but...
Hello Experts,
I turn my head towards you again seeking inputs to resolve an issue in bringing up a SVI on Nexus 5010 that I want to use for Peer-keepalive.
I have similar config on both 5010's. However, SVI on switch is up and not on other.
F...
Hello Experts,
I need your help with a configuration bit for Object based NAT - Natting two public IP to one private IP.
I am asked to nat two public IP to one private IP 8.xxx.xx.90 and 8.xxx.xx.92 to nat to 10.53.19.8. 8.xxx.xx.92 nats to 10.5...
I am planning to upgrade Cisco 3850 stack switch and turning my head at the experts here for inputs/help.
Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.03.04SE RELEASE SOFTWARE (fc3)Technical...
We are planning to have a ikev2 l2l between ASA and Cloud VPN gateway.
I am here to understand if ASA 5550 platform with code Version 9.1(7)4 supports ikev2 site to site tunnel.
This platform has an ASA 5550 VPN Premium license.
Regards,
Raghav
Hi Kirk,
Thanks for your time, I verified and see interface-vlan 1 is enabled.
sh feature | i endhcp 1 enabledfex 1 enabledhsrp_engine 1 disabledinterface-vlan 1 enabledlacp 1 enabledlldp 1 enabledsshServer 1 enabledtacacs 1 enabledudld 1 enabled...
Hi Ajay,Sorry, I got caught up with priority issues and couldn't keep a check here. Yes, your understanding is correct.We wish to remove the NAT for 10.53.12.14 (this will get decom) and point both public ip addresses (8.xxx.xx.90 and 8.xxx.xx.92) to...
I created a new object SIP 4 with same private host IP of SIP3 (SIP3 and SIP4 has same private IP), but natting each of them independently (SIP3 to 8.xxx.xx.92) and (SIP4 to 8.xxx.xx.90). Let me know if below should work or will run into any (what) p...
Hi Narayana,Thanks for your response. So what is the best method to have 2 public IP's nat to one Private address. I am not restricted to object based nat only, I am looking/open for other options as well.Key is to make it work.Regards,Raghav.
