hello is there any way to have a switch port detect that a access port is down, shut the port and no shut another?
we have a very important piece of hardware that has an exact copy running right next to it, and a cold spare on the shelf. as it stands...
i have a new Cisco Catalyst 2960X-48FPD-L and in the spec sheet (listed below) it shows 48 10/100/1000 Ethernet ports/2 SFP+ ports. but in the CLI it shows this:
interface GigabitEthernet1/0/47!interface GigabitEthernet1/0/48!interface GigabitEtherne...
i have a new Cisco 2960x and an existing HP 2910al. I am OK with the set up i interface hp and Cisco all the time with copper but this is the first i have had to with fiber. i know Cisco switch will want a Cisco gbic (can get around that with service...
per the documentation its is in standby mode
"Configure a physical Layer 2 interface (or port channel) as part of a Flex Link pair with the interface. When one link is forwarding traffic, the other interface is in standby mode."
