Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone, I have a query regarding SIP trunk configuration on CUCM. Below is the setup: CUCM 1 (SIP Trunk, DP:5060) >>> CUCM 2 (SIP Trunk, DP:5061) If I configure SIP trunk from CUCM1 towards CUCM2 using port 5060, but on CUCM 2 I create a SIP ...
Hello Everyone,
I am trying to upgrade the firmware on Cisco 8831 conference phones but getting the error as per the screenshot. Any suggestions on how to deal with this?
Thanks
Hello Everyone,I am having trouble in registering CIPC with CME. Debugs are attached for your reference.I am using CME version 9.1 and CIPC version 8.6
Hello Everyone,I have two sites: HQ and Site C. I have one Cisco 9971 at each site. HQ site is having CUCM 9.1.2 whereas Site C is CME. HQ router is configured as CUBE. The two phones talk to each other via CUBE. Whenever I make a call between two p...
Hello Everyone, I have MX200G2 registered on CUCM. When I dial the other video endpoints registered to CUCM the call works fine. Now if I want to dial any user outside my organization i.e I want to dial any Public IP the call does not go through. Can...
Please verify your region settings between phone and CUCM, CUCM to CUBE. In your debugs there is cause code of 47 which means no resources. Looks like some media resource is needed in order to complete the call. Also, add the bind interface command i...
Hi Michael, For the phones which are negotiating on 100M can you please what is the setting on switch end and phone page? As per the best practice the settings on CUCM and switch end should be Auto/Auto.If you need to change settings on the phone its...
Hi Faisal, This is possible using SIP trunks. Please refer the below document for integration process: https://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/interoperability-portal/communications-manager-release.pdf Thanks
