Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I deployed a new cisco 9500 to be trunk to cisco WS-C3560-24PS. However, on the WS-C3560-24PS when I tried to remove the switchport trunk encapsulation dot1q. I get Command rejected: A port which is configured to "trunk" mode can not be configured to...
Thanks man. I tried the to use dynamic auto no success. However, when I connected the switch to another switch same model I could trunk with no problem. but I replace the switch to 3650 this switch I can trunk to Cisco 9500 with no problem.
on the beginning. I wasn't able to console, but I rebooted the switch I default int gig 0/1, However, the switch keep forcing me to use dot1q. All I need is switchport trunk allowed vlan xxx, xxx,xxx and switchport mode trunk. because the cisco 9500 ...
