PolyCaleb
Level 1
Level 1
Member since ‎09-29-2014
‎11-02-2023

User Statistics

  • 12 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 1 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
10 Discussion Posts
1 Reply
1 Helpful Vote
5 Replies
CCP Member
1 Accepted Solution

User Activity

User ID: PolyCaleb SSOID: PolyCalebError:ProjectId : 2122345904select sso_id, c_ccp_status from users where login = 'PolyCaleb'userDetails output = { "status" : "success", "message" : "", "http_code" : 200, "data" : { "type" : "users", ...
User ID: PolyCaleb SSOID: PolyCalebError:ProjectId : 40722216select sso_id, c_ccp_status from users where login = 'PolyCaleb'userDetails output = { "status" : "success", "message" : "", "http_code" : 200, "data" : { "type" : "users", ...
So I have a situation where I have a layer 3 switch (R3-1) that is 2 hops away from the subnet on R1 (another layer 3 switch).  It has formed an eigrp neighbor with the two layer 3 switches (R2-1 and R2-2) that are one hop away from R1 however it is ...
I'm attempting to figure out how to get my 3560X to load balance a LACP port-channel that is going to a server.  So about 90% of the traffic goes through one port.Port-Channel 4:                         GigabitEthernet0/14:                    Gigabit...
I'm using a 3560X-24P running 12.2(55)SE5 IPBase. I should be getting a lot more packets queued into my queue 2 than I am and I'm not sure why I'm not.  Any help would be appreciated as it makes it very hard to properly allocate buffers if the packet...
Community Statistics
Member Since ‎09-29-2014 12:32 PM
Date Last Visited ‎11-02-2023 12:17 PM
Posts 12
Total Helpful Votes Received 1
Helpful Votes From