Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a weird issue with some server LANs that terminated on FWSM.
In this LANs used static IP-addressing.
All of the servers are VMWare VMs.
And after reboot or restarting network interfaces on these VMs, (Windows and Linux) OS reports "Dup...
Hello
There is a problem with Dial tone and DTMF on 7900 series phones on CUCM 7.1
Sometimes at any of the IP phones when phone get hook-of I hear dial tone but not hear key press tone when typing a number.
Phone can make and answer calls. But when I...
Hello!Today i suddenly met the restrictions in Nexus 5596 System version: 5.1(3)N1(1a).The target is monitoring one source (10Gig Ethernet port), to two destination ports. (This is third party active/passive monitoring & IDS).And restriction is:One m...
Hello everyone,I configured the IVR (vxml) script fo CME, for extension numbers. ("Welcome, for dial enter the short number of worker or wait for operator")Then i did a test call from sip trunk to CME,Calling-number with label: XXXX (XXXX)Called-numb...
Hello,I have a question about receiving incoming calls, when Publisher is down.My provider gives me IP telephony with two SIP-trunks for outgoing call, and one SIP-trunk for incoming call (Routed to Publisher), therefore, when Publisher is down, we c...
I sniffed streams with working and problem phone and noticed:
Stream of working phone:
Signal flow going through Subscriber, voice flow going through Publisher
Phone uses inband DTMF using changing of RTP Payload
CUCM uses this DTMF method too over S...
I sniffed streams with working and problem phone and noticed:
Stream of working phone:
Signal flow going through Subscriber, voice flow going through Publisher
Phone uses inband DTMF using changing of RTP Payload
CUCM uses this DTMF method too over S...
Hello,Thank you.But I operate Call Manager Express System.I'll try to describe again:When users forwarding or transfering calls to local destination. On the display on destinated phone we see "Forward:X To: Y By: Z", but I want to see just "From: X" ...
Thank you, EmilBefore I try this, i want to clarify that CME can route calls from SIP-trunk to SIP-trunk without "border element mode".I never met this configuration, so i afraid about this.Can you dispell my doubts?
Thank you Suresh,As i understand, i can use CME instead CUBE, cause it has SIP to SIP and dial-peer with preference functionality? If i right, why CUBE better than CME in that case?
