About aaronhill1

aaronhill1 · 02-23-2015

FIPS: Flash Key Check : BeginFIPS: Flash Key Check : End, Not found, FIPS Mode Not Enabled----------------------------------------------------------------------------------------------------FIPS: Flash Key Check : BeginFIPS: Flash Key Check : End, No...

aaronhill1 · 01-29-2015

Hey guys i got my cucm server up and running and registered the phone Mac in add device in my cucm but my phone just sits in the upgrading screen and doesn't get any farther than that, Any ideas as to what i am doing wrong? Should i just be able to ...

aaronhill1 · 01-23-2015

Hey guys i am brand new to The whole cucm server stuff. Long story short i bought a MCS server with CUCM 7.1 installed on it. I am stuck on how i set it up so i can log into the ip address from my desktop.right now i have the server plugged directly ...

aaronhill1 · 12-08-2014

Was told by another user on here to change the confreg to 0x800 so i tried it i enteredconfreg 0x800reset After the device did that i started getting random jiberish like the baud rate is wrong on the console. and i cant read anything or do anything ...

aaronhill1 · 12-08-2014

Bought 3 used switches and they keep booting to a company prompt and wants a username. I have changed to register to 0x2142 and tried sticking a different ios flash disk in with no luck. System keeps booting to image even when booted from rommon flas...

aaronhill1 · 01-30-2015

ok new update, I got a 7960 phone to come online but the 7965 will not register

aaronhill1 · 01-30-2015

ok i keep reading things about the phone having to pull from a tftp server, I set the router and switch up from a cisco voice lab manual and now the phone is advancing to a configuring CM list but is stuck at this screen

aaronhill1 · 01-30-2015

i took basic switching and routing in school, We touched a slight bit on phones but only set up a router and basic vlan on a switch, Never touched the cucm. I thought that the router can provide dhcp, Do i need a DHCP and FTP server ?

aaronhill1 · 01-30-2015

does the cucm need a router on the network if i am just connecting a phone to it to learn? also if it does need a router do i need to add a gateway?

aaronhill1 · 01-30-2015

not quite sure how i do that

Member Since	‎10-22-2014 02:05 PM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	31

User Statistics

User Activity

FIPS not found on 3750 switches

setting up a cucm server and adding phones

Setting up a cucm network.

Help was given bad advice and now device inst working

Used switch keeps booting to a company prompt no matter what

ok new update, I got a 7960

ok i keep reading things

i took basic switching and

does the cucm need a router

not quite sure how i do that