Hello all! Thank you in advance for your assistance.I have four C6800-SUP6T supervisors in a C6807-XL chassis that have 2 FortyGigabitEthernet ports on them. Software release notes indicate that 40GB-to-4x10GB breakout cables are supported on this ...
I have a number of Catalyst 3560-CX switches operating in Instant Access mode. They are connected to a pair of 6807-XL chassis / Supervisor 2T modules. I now need to connect 3 additional 3560-CX switches to a 6816-X-LE. On all documentation on C...
Greetings! Thanks for the help in advance.
I have a situation where the SLA target I want to test against to control a route insertion (redistribution via eigrp) will start to succeed when traffic is redirected via an alternate path.
Consider the ...
Hello,
The CUCME data sheet does not show support for the following item:
Cisco IP Phone 8800 Key Expansion Module
CP-BEKEM=
Also the item's data sheet itself mentions CUCM and SRST, but does not mention CUCME specifically.
Can someone confirm that...
As it has been referenced a couple times in the support forums, I found the MIB for charting concurrent SIP calls (per protocol/per dial-peer, etc). I would like to chart per dial peer. With SIP, it appears as these call counts are divided into S...
Additional Data: I am running the new Firepower 2100 series, with the first generation of software that supported Anyconnect on Firepower.
SOLVED/UPDATE: With the changes to the profile as stated above (Certificate Store Override and Store = Mac...
I know this issue is 2+ years old, but any fix? I am running into this today.I have a valid machine cert issued by MS PKI via Group Policy in the local client's certificate store (Computer) that has EKU of "Client Authentication" and "Server Authent...
Thanks for the reply Collin!
I believe that's not what I need - I need the test to the host to not be influenced by the route itself. i.e. I'd like my test data (from the sla configuration) to be routed on the same path (across CUST_A) regardless...
