Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have found an interesting note in the 6500 IOS configuration guide for SPAN on an EoMPLS bug that won't allow it (the EoMPLS port) to be the source. Does this hold true for an IP over MPLS over PoS configuration? We need to SPAN the interface to a ...
I have reported this to TAC but have found that I have to run WINS in my network for the failover wizard to work properly in a new install.I am not sure if they are going to have the BU notified but it seems to be a big problem since WINS is going th...
I am currently running a DiRT restore on a new MCS-7845-H1 using v 3.1(5) of Unity. I am only restoring the DB as the Exchange is off box (UM Config). The restore process has been running for over 1.5 hours which seems a bit long for 150 users. Is...
Is there any way to get rid of the annoying "Unknown Caller" for Caller ID (it only matches known callers of the CUE system). I would say 75% of our calls are outside callers.
Update: We resolved this issue by adjusting the MIME-relevant portions of the audio itself.The problem was not the WAV header, metadata, or encoding — it was specific μ-law byte patterns inside the recording that the ES07 MIME filter incorrectly inte...
This is an old thread but if someone stumbles across it I have an update. I am on 14SU3 and ran into this exact issue.
As per the case notes, our hostnames and our server names were out of alignment. I have this on 5 clusters, all 5 fixed as we did a...
If I am not mistaken, as per your configuration "CME config.txt", no supplementary-service sip moved-temporarily, is not there. If it was then we would have a different problem, why is it sending the message. The originating CME (CME2), 10.11.3.220 /...
For future posts please provide a clear call flow and some way of following the original configuration to call flow. It was redacted and incomplete so I had to piece together the call flow and configuration. Basically, it appears the call is failing ...
