Hi Cisco,When an 1131 AP is sitting flat, what polarity are the antennae in ??I believe the antenna on both the 802.11a and 802.11b radio's are simple dipoles ??
Would someone post a link to any URL which fully explains the CCA setting on 1300/1400 bridges?The setting value can be 0 - 90 and a TAC person advised me to change the setting from 0 to 62 (default) but did explain why he considered this change sign...
Since upgrading our ACS to 3.2.3 from 3.2.1 we are no longer able to have our wlan clients authenticate using generic or MS PEAP.Just wondering if anyone else has been experiencing this problem. Cisco TAC has yet to offer a remedy.Dave S.
After trying this upgrade in both a 1200 and 1100 series AP I am extremely disappointed in the througput I am getting.Even when set to "G-only" and operating in an area which is free from any other RF traffic I can only achieve 20.5Mbps.Perhaps I hav...
Hi Giuseppe,I think you are correct on the EIGRP Stub in that the L3's currently have the IPBase IOS running.I believe with that IOS feature set I can only run EIGRP in "Stub" mode on these.What confuses me is that I have EIGRP nei between the two L3...
That would be excellent..I have a couple of 878's in back to back with a dsl link..These are in bridge mode and although a client connected to the CPE routers switchport works perfectly, I have no management capability for the routers themselvesThe c...
Check the user group properties in the ACS that your wireless users are authenticating against... there is a property near the bottom called "ieee session timeout" or something to that effect (in seconds)If you don't see this property then you will ...
I believe you have to enable PSPF (public secure packet forwarding) to have two wireless devices connect while using the same AP... this is not allowed by default