Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All.I have a CATALYST 9500 switch.when the command "reload" is executed the switch reloads and goes into a endless loop and then shows the following error:error-adelphii2cwriteactAny idea how to solve it?Thanks!Danny.
Hi all.Is it possible to replace the PSU in a WS-C3850-48XS-S ( front-to-back power supply) to back-to-front power supply in the same chassis and get opposite air flow?Thanks,Danny.
Hi all.I have a two catalyst 3560CG-8TC-S running IOS ver c3560c405ex-universalk9-mz.152-2.E2 (IPBASE).The switches accept the configuration for TrustSec in "cts manual" but the switches interfaces are blinking in orange and the status is not conne...
Hi.I have a cisco 2960S 24 x 1 giga ports with an uplink of 10 Giga connected to a IBM server.When I am sending jumbo frames (9000 Bytes) from up to 6 end devices (connected to 1 Giga each), there are NO packet drops.When I connect one more end de...
Hi.I am working with ACS 5.5For testing I have tried to get accounting messages from a 2960S switch configured with AAA new model for Authentication Authorization and Accounting using TACACS+.Any idea why I don't see any reports regarding accounting...
Hi Emanuel.I have the same problem connecting 2921 router with CME to a BE3000.Can you help with configuration needed in the Router in order to enable CUBE and establish a SIP connection between the two?Thank you.Danny.
