Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How I can configure the access point or the controller to limit a certain usage cap per user? ( usage cap threshold)Users are using the Wireless network for Internet activity so How I need prevent each user to download/upload more than his cap. (20GB...
Hi there,It is my first MAN deployment. I will use the 6513 as the core switch and the 3550 as the edge switches to the customer.The customer has 9 locations. The customer asked for interconnection between the 9 locations and his Data center in his H...
Hello,I was wondering how service providers guarantee their security protection in the Metro Ethernet model, especially when Internet is one of the applications used over the Metro network.For example: The customer edge switch (3550) is connected dir...
When i installed the 7920 with CCM3.3(4) using APs 1120 ,i noticed that we have to disable the power save option in the phone settings the phone operates normally ,but when it is enabled the phone starts to lose its connection with the call managers...
how to get form the call manager reports for running 7912 models for certian range of numbers , serial numbers of ip phones ..and stuff like that Our CCM is 3.3.4Any ideas
Hello Raj,Thanks for your reply , but I have couple of questions Do we need to upgrade this Ethernet to layer 3 for traffic shapping for both voice and video ? if not Can I change the 6513 with a layer 2 switch if I dont need any routing between th...
Hello,You mentioned that NAT will be performed on the aggregation layer (6500) using the FWSM . What is the best layer to do NAT here, is it the CE or the Core layer or the aggregation as you mentioned? Another question, where is the security in the ...
I have data traffic run on the same wirless network and the covergae is perfect , OK , I POSTED MY CONFIGURATION HERE if any one can advise what is running wrong
I do that actually , but what appears is that the ip phone loses its Wifi connectivity with the access point and therefore lose its connectivity with the call managers . all of this happen when the power save mode is ON !!!Any explaination
