Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
I my environment we have upgraded cisco Nexus 5596 and it took approximately 11 minutes to become completely functional.
When the switch starts bringing up the Ethernet ports of the module at an approximately at 07th minute there was no c...
Hello All,
I'm troubleshooting the performance issue of traffic through the GRE tunnel between two sites. I have noticed the tunnel bandwidth and receive are set to 8 Mb as default.
- Does the default value of 8Mb mean the tunnel would rate limit th...
Hello All,
I'm working on OSPF configuration and I have query on setting the MTU over the L2 path between L3 endpoints.
Topology:
Firewall(L3 SVI with an MTU of 1500 bytes) <=> Nexus 9K (L2 trunk with and MTU of 9000 buytes) <=> Nexus 9K (L2 trunk ...
Hello All,
I'm working on a design issue and would like know the Cisco best practice to configure the spanning tree port type for the L2 connectivity between VDCs?
In a scenario VDC running on Switch A to VDC running on Switch B and both switch A an...
Hi Team,
I'm working to fix the L2 redundancy issue to the end points connected to the leaf switch. End points are connected to both leaf 1 and leaf 2 switches and we have a layer 3 interface configured on the upstream Firewall for all the Layer 2 VL...
Thanks a lot Reza. The difference with the spanning-tree port type network and spanning-tree port type normal is the bridge assurance feature.
Since the BA feature is disabled on spanning-tree port type normal, Do we need to enable loop guard to pre...
Thanks Reza. just to confirm again on my understanding.
1- If there is VPC between N7K and N5K then we have to configure the switch ports as "spanning-tree port type network"
what would be the suggested switch port types for the following scenarios:...
Thanks a lot Marcel. We have the design as like the Leaf switch 1 connected to primary firewall and leaf switch 2 connected to secondary firewall.
When the primary firewall is active I'm finding the endpoint IP address on the leaf switch. whereas w...
