Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, We have a Cisco 1941 running IOS 15.5M and the Zone Based Firewall with inspect rules.I need to de-configure zone-based firewall completely off the router. Unfortunately I have only remote connectivity. What is the best way to do this? Does a...
switchport access vlan 111
switchport trunk native vlan 111
switchport trunk allowed vlan 113
switchport mode accessHi all,what is the effect of the above?- it’s an access port, and can pass untagged packets for vlan 111- it can also trunk vlan 1...
Hi,
We have a need to ssh from a Cisco 3925 to a device which only supports the following hash algorithms:
hmac-sha2-512 or hmac-sha2-512-96
hmac-sha2-256 or hmac-sha2-256-96
hmac-ripemd160
Can anyone advise on an IOS version where the SSH client su...
Hi ,
Can anyone point me towards the correct MIBs/OIDs for identifying the card type, slot and serial number for the interface cards installed in 29xx and 1941 series routers running 15.1(4)M7 IOS versions?
I see there is a deprecated cardType OID .1...
Hi All, Just to clarify, I notice in IOS-XE there is the command 'platform inspect disable-all 'command Is there the equivalent in IOS 15.5M? After removing ACLs from interfaces, is there a better way if it doesn't exist?
After some pushing, turns out the Polycom at this one site was running an ancient version of firmware. Once it had been upgraded, the config worked fine.
Hi,I'm hitting a similar issue - we can connect to the video device (the mediacontrol channel ip) is being natted but the mediachannel Ip for some reason is not, in the same packet.Did you find a resolution?Sent from Cisco Technical Support iPad App
