Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have the next topology: Aironet 1702I (CAP)<-----------------cable-cat-5e-------------------> Patch-Panel <----------> Power-Injector<----------->switch small bussines SF548and my aironet don't power onr the port, don't turn on the led of t...
Hi I have a question with the selection of antenna, i wish to use the 1532E with the next antenna non CISCO, (L-com HG5817Y-NF); but I have doubts about the compatibility and if there is a danger for the 1532E. i the datasheet the antenna have a one ...
Hi I have a proble with the 3560cg and 2960cg, when i configure the port with "switchport trunk encapsulation doi1q " and "switchport mode trunk" on the interface for the connection with the WLC2504, don't have connection. I configure others WLC and...
HiI use the CISCO AIR-CB21AG con the software airmagnet, and i wish to know if i use the card for realizate a passive site survey with APs thah work with 802.11n.the SNR and RSSI obteneid with this card its the same for conections 802.11n?thanks for ...
Hi I have the next problem with the WAP 321:the university have 4 WAP 321, 1 of they it's work correctly, but 3 doesn't work correctly: 2 only work one day, There malfunction thereof, there no exist connectivity administration, and the conectivity of...
Hi For the HA (high availabilty) for the vmanage and using the concept of disaster recovery, is necessary have cluster of vmanage en both sites (in the hub central and the secondary) or we can enable only with 2 vManages (on both sites + 1 for the ar...
Hi Enrique
I have a questions about the APIC-EM that are part of the CISCO DNA.
With the version 1.5 from the app IWAN, i see that i can modify the configuration from the APIC, but when i realice some changes directly on the equipement and not with...
Hi scot in my case, i configure the 3560 with the vlan 1 for administration and the vlan 100 and 200 for my clients (i use the 2 vlans with 2 wlans from the wlc) and i know that the port must be Trunk, my management interface its taggin with the vlan...
Hi LuisThanks for the response, well teh configuration on WAPs ints the next:1 or 2 SSID for the clients with the respective VLAN (48,56)1 VLAN for the management (9)well in this case, the WAPs are in different areas, doesn't exist the roamming and t...
Other Question.Thank you for councils, and I have the following questions.With the PI 1.3, i could realize a monitorig generating PING constantly or not?, usually i use this protocol for verify the connectivity.and i whish to know if the PI 1.3 can b...
