Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is a short video showing the local status pages and options for a C9300 Catalyst/Meraki switch using thededicated ethernet management port on the back of a C9300 switch when the switch is setup to be managed by the Meraki dashboard. This is ver...
Here is a photo gallery and unboxing of a Cisco WiF-7 CW9176I-RTG Access point.I needed some visibility and access to the 6Ghz frequencies so I upgraded some older MR42 APsto the new CW9176I APs. The single PID made ordering easy and the include bra...
Here is a link to a Hi Res photo (flickr) gallery that has some photos of the different Cisco Access Point mounting brackets and what is include with each of them.This includes the following AP brackets:AIR-AP-BRACKET-2 and An AIR-AP-T-RAIL-F Gall...
Here is a small photo gallery and unboxing a MG52E.
It comes alive just by plugging it in, in my case I was using an MX85 and POE from one of the Internet ports.
The MG52E ships in an all paper/cardboard box - there is NO plastic on/in anythin...
Small project to update some older Meraki MV-71 outdoor Gen 1 cameras with newer Meraki MV-63 4MP outdoor cameras.Check out the unboxing and install gallery here There are also gallery notes on the photos. Install was easy using the included mounti...
Just had to reinstall and setup my Raspberry Pi sensor - SSD card went bad with all the power hits from the weather last week - the new v3 directions worked well and the image link from stmarin that was posted also worked great - thanks!
