Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi everybody I will be very thankful if someone can advise how to measure the power consumption of a C6509E switch and to show its variation with time. in other words: do the actual power consumption of the C6509E depends on the size of data being pr...
Hello everybodyI need to know the maximum of IP cameras that can be supported with 1 RU VSOM, I currently have 108 IP cameras and 3 1-RU MSPs running as follows:1 OM & MS with 35 IP cameras1 MS with 35 IP cameras1 MS with 38 IP camerasthe system is...
HelloI am trying to configure site to site vpn between Cisco ASA and Cisco router 3825, I need to establish the vpn connection with an interface that has security level of 90.I followed the procedure shown in the following link:http://www.cisco.com/e...
Hi,,,I am working in a university and we have a demand to build a video surveillance system, I viewed all data sheets of Cisco cameras and I found that no of them have IR leds to be used in low light conditions.The problem is that the system is requi...
Hello everybody,I need answers for the following 2 questions regarding Router 7304 with 7304-NPE-G100 engin1) what is the maximum CPU and memory utilization that is not recommended to be exceeded?2) is it concidered as a blocking device, i.e. it is f...
hi marin_ottoyour case is very similar to mine. I am trying to fetch a relation between actual power consumption and (CPU or BW) utilization; and another relation between actual power consumption and time. so may you advise plsbest regards
thank you scott. but please may you explain to me the following:1) what is the VSOM CPU and network IO maximum values at which I should know that no more expansion is possible.2) in case I have a user who is live monitoring one or more cameras by us...
I meant by through a DMZ: DMZ interface configured on the ASA itself which is one of the VPN peers and not through the ASA outside interface which have security level of 0. (end to end connectivity between peers were verified but VPN was not working)
thank u very much it was helpfuli think this is a new model cs it was not shown beforebut do u think that it will be possible to power the external leds with the same PoE connectionbest regards
hello,I would like to thank you for your interest in my issue. Kindly find the attached pdf document that shows routers models and "Fast/CEF Switching" for each of them. It is written for the 7304-NPE-G100 a value of 562 Mbps and 1 MPPS. I would like...