Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im in an effort to implement client based authentication for VPN users to connect to corporate.The configuration on the perimeter seems to be correct as I can validate with different windows computers.However, I am having issues with Mac OS where I g...
For long time we have lived with only the global domain.Now we are facing the need for at least two domains to isolate admin tasks. Does moving from global domain to a multitenancy disruptive? is there anything I should be aware before performing the...
Is it normal to have "Not avaiable" under connected interface for "show fcns database detail" on a native FC target device?port-wwn (vendor) :10:01:d0:49:ea:52:9a:f0node-wwn :10:00:d0:39:ea:52:8a:f0class :3node-ip-addr :0.0.0.0ipa :ff ff ff ff ff ff ...
When looking under Analysis > Intrusions > Events, I am not able to see any information under "Packet Information"Is there anything I need to do to enable this information? It would be intresting to see more info after an Intrustion Event has been dr...
OK, yes I read this document but I also wanted to make sure it applies to FTDv HA. I wasnt sure if Live Migration was supported. Can you confirm this is the case?
Configuration steps seem simple, did you encounter any issue? Reading at the Configuration guide to build the HA pair I am reading a note under "Using CLI ro Resolve Device Registration in Firepower Management Center High Availability" where it says:...
