Steve Coady
Level 1
Level 1
Member since ‎03-29-2005
‎12-14-2020

User Statistics

  • 506 Posts
  • 1 Solutions
  • 4 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
First Discussion
70 Discussion Posts
60 Replies
40 Discussion Posts
350 Discussion Posts
400 Discussion Posts
40 Replies
300 Replies
300 Discussion Posts
450 Discussion Posts

User Activity

OUTSIDE-DIST#sh proc cpu | ex 0.0Core 0: CPU utilization for five seconds: 85%; one minute: 86%; five minutes: 88%Core 1: CPU utilization for five seconds: 83%; one minute: 93%; five minutes: 83%Core 2: CPU utilization for five seconds: 100%; one min...
All We have a remote site (c1111) that has a S-2-S vpn to ASA (asa9-12-4-4-smp-k8.bin). topology: Remote site: Cisco 1111 - Internet (vpn) - ASA - Internet The VPN works but access to Internet does not. Remote-Site config crypto isakmp policy 1encr 3...
All We are experiencing catastophic weirdness with failover between Pri/Sec. While on Pri, the "no failover" command was run.    I lost connectivity to Primary    Internet connectivity was lost. I think this was because Prim/Sec both thought they sho...
All I am an NE in a large, complex network that is getting larger fast. Recently we built a new site and while checking routing to make sure we have redundancy built in, I came across the following while looking at eigrp top.  sh ip eigrp topology 10...
All   We are beginning to use ikev2 for site-to-site vpn's My current vpn's use the following group-policy:   group-policy DfltGrpPolicy attributes vpn-tunnel-protocol ikev1 l2tp-ipsec ssl-clientless webvpn  anyconnect ssl keepalive none  anyconnect ...
Community Statistics
Member Since ‎03-29-2005 01:28 PM
Date Last Visited ‎12-14-2020 07:42 AM
Posts 506
Total Helpful Votes Received 15
Helpful Votes From
Helpful Votes Given To