Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anybody knows exactly what the command "logging event addr-flap" does ?Does it mean its enabled by default ? Enable and Disable Address Flap messagesThanks.
Hi everybody,i'm getting mad trying to make it works this configuration about fxs and sip.I can register the fxs on sip server , i can call from fxs to a phone also registereded on sip server but not the other way , form the sip phone to the fxs.The ...
Hello,i'm looking for a documented solution to connect two sites , i need a box to be put in front of an isdn bri pbx with 3/4 lines that can let the call exit to the isdn pstn or to internet sip in order to connect to the remote site or other destin...
Hi all,i've got this situation where my switch its not the root .VLAN0010 Spanning tree enabled protocol ieee Root ID Priority 32768 Address 0002.b9cd.96c1 Cost 3138 Port 12 (FastEthernet0...
Hello,does anybody knows exatcly what happen to a Pix URprimary unit if not connected any way (no lan or serial failover cable)to a secondary FO unit ?We where upgrading from a pix515 to a pix515e so we left the new pix515e-ur unit alone and we had s...
Salvatore,i agree with Paolo .( I did not see Paolo reply before my last answer )At this point you should "bypass the converter, and connect SHDSL directly".
Salvatore ,i was looking at the modem , i think i see an alarm led lite , no led for g703 or shdsl line .Can you do a kind of loopback on g703 and see if shdsl line led come up ?(any modem manuals ? or ask telecom)Patrizio
Dear Salvatore,do you use the original cisco cable for the card EHWIC-4SHDSL-EA ?How do you connect the impedance adapter to the cisco cable ? Have you followed how the connection are done inside the impedance adapter and in the"RJ adapter" between ...
Dear Salvatore,i think there is an impedance mismatch , you should have rj45 port on the Telecom modem and not bnc .If they use bnc and you use rj45 must use baloon to adapt impedance !What modem it is an Aethra ?
