Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,
need help on a lab setup. I am doing BGP between two AS and full mesh iBGP in both AS. Now after checking I am able to reach each other loopback address which I used for peering. I advertised 2 networks to far end AS and I am able to pi...
Hi Everyone,
Can someone correct me on a BGP issue. It's not a real time environment. There are two customer's running BGP and in different AS. One location is using RIP and other is EIGRP. Peering between two routers using loopback IP addresses an...
Hi team,I need to know while creating the corporate directory on CUCM is that possible to give preference to any particular entry for that user to be selected by default on the endpoint.Like If I have one extension and Directory URI configured for th...
yes but I can see you have asked me to ping with source loopback of R2. earlier I was just pinging it from R2 without any source. Does it mean BGP only works if you are pinging with the router ID as a source?
Now I am able to ping R2 from R7 using ...
output of ip route from R2
R2#sh ip routeGateway of last resort is not set
1.0.0.0/32 is subnetted, 1 subnetsD 1.1.1.1 [90/2297856] via 192.168.1.1, 03:03:02, Serial0/0 2.0.0.0/32 is subnetted, 1 subnetsC 2.2.2.2 is directly connected, Loopback0 10...
Hi From R5 towards R1.
one is 100.100.100.100/32 loopback and one is 7.7.7.7 which is the loopback of R7 as per the diagram.
R5 has learned it through IGP protocol.
Hello,
I advertised from R5 to R1..R5-->R1. One is the loopback on R5 and other is it has learned through IGP(RIP protocol) which basically R7 advertised to R5.
