Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have:
vlan A for wired voice
vlan B for standalone AP mgmt
vlan C for controller AP 1 mgmt zone
vlan D for voice from controller AP1 zone
vlan E for controller AP 2 mgmt zone
vlan F for voice from controller AP2 zone
Which is the best way ...
Hi everybody,
It's time to upgrade our core network,so i pointed my choise on Nexus 7K 9K solutions.
Nexus 9K available in "classic" and ACI modes. Which one will you advice?
Anyway we're going to use 10G copper links with our server farm,but on ...
Hi,We've about 300 Cisco devices in our network.Couple of weeks ago i've noticed,about 30 new vlans appeared on all the L3 devices.I can confirm that all these vlans do not belong to our network.I tried to identify source of these foreign vlans,but ...
Hi,
I've to apply position in the queue to our production IVR.Like "you're second in queue" and etc.
I've faced with some problems with it.
Can anybody share simple aef with position in queue subflow applied?
Thank you.
UCCX Premium 10.6.1
Hi,
We're using CCX 10.6 Premium.
I've been asked for provide some statistics,how many times which menu was selected and etc.
Most of select steps used route customer not to CSQ or transfer,but just some informational menu with wav welcome prompt.
...
Hi,According to the logs everything seems to be in order from router+FXO side.Just try to confirm- GSM gateway support polarity reversal.I faced with such kind of behavior in the past,in my case solution was add to the FXO port confirgsupervisory ans...
Hi,even if you will perform hard or soft reset of the phone it will erase all the previous settings and other sensitive info.Just do not forget check "reset all settings" as well.
Hi,Maybe you checked it already, but try to check target RP and caller ID format for the same HG used.As Leonardo wrote already, it will be great if you share HP HG and LG settings.
Hi everyone.Faced with same issue few months ago. Maybe this will usefull for someone also )) The point is- if you have FANs with airflow "Front to Back" and PSU model is "Back to Front" airflow supported you will get exact error message when bootup....
