Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear community,
I tried to update our good old C2960 switches a last time from 15.0(1)SE2 to 15.0(2)SE11.
Sadly, after booting up with the new image, every C2960-48PST-L running into an memory allocation error. The switch is still "switching", but ...
Hello community,
I upgraded an ASA 5540 from 9.1(7)23 to latest 9.1(7)31.
Sadly at the first boot of .31 interim, the asa not booting up and hung.
After changing boot image back to .23 at ROMMON, the ASA booting up fine.
Did someone have this iss...
Hello community,just a question regarding what to do, if the machine code of an UAC Standard installation has changed.There is an other NIC installed at the pc, so the machine code is changed.At cisco.com/go/ac or cisco.com/go/license I cannot find a...
Dear community,I have the strange behavior, that whole device work center is empty after I had upgraded to 10.5. No more call managers, unity connection or phones available.A rediscover or deleting and adding a new credential policy doesn't bring the...
Hi community,I am a little bit confused regarding the need for rollout the sensors around an organisation... since callmanager (>= rel. 8.5 I think) can deliver CVTQ data, is there any benefit, what can do the 1040s better..? We are still running lat...
Hi Leo,
thank you for your support. I attached the console output and the output of some memory stats.
The running config is included (cleaned) too.
I tried the older SE10a release and there the result is the same... after reboot a "%% Low on memory;...
Thank you very much. After the workaround of bug CSCvh91399 the build 31 is running fine. Two other ASAs are not running into this bug. All of them was at same release 9.1(7)23 before updating.Did someone find the updated release notes of 9.1(7)31......
Hi Aamir,
did you already uploaded the bootable ISO to PCD and PCD says it is valid? If yes, then PCD will mount his own pcd_NFS datastore to esxi. At second step, PCD will mount the intial ucm-config (with exported ip, hostname, ...) as floppy image...
Hi Jürgen,
I struggled at the same point of migration of CUCM 9.1 to latest 11.5 with pcd. The export of all cucm nodes finished with no error, then the new vm powered on but nothing occurs. Neither floppy config nor bootable ISO mounted to the vm so...
Hi again,
today I updated to PI 3.0.2. Somehow it is possible to delete incidents at summay list... it works better with Safari then Firefox and sadly it is not very fast and "stable".
Thanks and greetings,
Chris
