Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have upgraded switches like cisco 2960/3560 & 3750. But never upgraded cisco 6500 switch.I checked on the cisco website for the steps to upgrade but its little confusing for me to understand some of the terms. I am planning to upgrade the IO...
I upgraded one of our cisco 2950 switch with the IOS image :c2950-i6k2l2q4-mz.121-22.EA13.tar .After upgradation ,enabled ssh v2.Its accessible through ssh, but I want enable https to view the web inteface.I tried using the cammand " ip http secure-...
I upgraded the IOS of cisco 3560G POE switch with c3560-ipbasek9-mz.122-35.SE5.tar.After upgradation the switch is rebooting continuously.the follwoing is the output taken fro hypertrm,%Software-forced reload 00:01:09 UTC Mon Mar 1 1993: Unexpected ...
I am trying to copy the running config to a tftp server,but I am getting the belwo error,tftp ip -10.91.111.12sw-01#ping 10.91.111.12Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.91.111.12, timeout is 2 seconds:!!!!!Success rate ...
I upgraded the ios for cisco 2950 switch with c2950-i6k2l2q4-mz.121-22.EA13.tar.After upgradation,i was able view the cisco web browser,by using the link http://10.x.x.x/.But after sometime ,i tried & its not working now.I m getting the below message...
Hi David, Can u pls provide me the steps to configure CA & SCEP on Windows 2003 server. Also how to configure the Certificate Authority to issue certificate. Awaiting your reply.
Hi Milan,As u can see in my discussion..... I already mentioned that I enbaled ssh..that means its a crypto image.If it was not a crypto..then I cud not be able to enable ssh.For your clarification....if I disable ssh..then http is working.(As i used...
thanks a lot for your help.But I have few questions....1.could u please explain me about the below output :POST: PortASIC CAM Subsystem Tests : BeginHTD POST: Basic Test FailedPOST: POST FailedPOST: PortASIC CAM Subsystem Tests : End, Status Failed.....
ganesh,thanks for yr replies..........But as i already mentioned that.....i m using the same tftp as u suggested above..ie tftpd32...I also I tries using pumpkin....but facing the error.if u a have any other suggestions...pls suggest.
