Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I must connect a Netapp Filer with FC and UCS with FcoE on the same Nexus 5548UP, to communicate between the Netapp and UCS over N5k!Topology: Netapp-> FC -> N5k <-FCoE<-UCS Is this a supported design and how to configure it?Thanks to all
Hi all,I tried to upgrade my S&S from Version 5.2.1 to Version 5.2.2.Before I upgrades DMM/DMP4400G from V5.2.1 to V5.2.2 without any problems.Errormessage on my Console S&S: System detected is unknown!Running V5.2.1 does not show correct AAI informa...
Hi,we have a problem with DMP4400G and S-Video/Mini-DIN Connector! Customer Cables are different from the S-video-connector on the DMP4400G!Cable here in in Germany has shorter and thiner PINs, so S-Video-Cable and DMP-Connector are not correctly con...
same errormessages seen an Quad-VSS C6807/Sup2T/Version15.1(2)SY4a!! Reseating, new slot and VSS-switchover does not resolve the issue!!No solution from TAC
Hi,had also a problem with host-Settings!!Look atCSCtn03766 Bug Details "ecs.host" setting in web.config is mis-configured. Symptom:In SnS / MXE integration scenario, SnS can't submit job to MXE with the following error messages:Unable ...
Hi David, hi Thomas,your FaQ does not resolve my issue! I burnt my S&S update image also with a Hp Probook 6540b (!), Software is ImgBurn V2.5.2.0, and the lowest speed (2.x). The MCS serialnumber is still visible in the BIOS, but not on the AAI/show...
