Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a requirement for Shoretel integration with CUCM for call routing. I configured the T1-PRI-QSIG between 2921 MGCP gateway and a Shoretel and the PRI is up. When the calls are placed, I see the call on the gateway but then immediately see a dis...
The QSIG PRI is working now after converting the gateway to H.323. I suspect that the latency was causing the dropped calls as with MGCP, the latency between GW and CUCM was around 150 msec roundtrip.Thanks for help.
Thanks for your reply, Chris.I tried reboot of the router to no avail. The router is configured for Network and I verified that the T1 is clean with no errors. According to Cisco, this error is a temporary failure but in my case it is consistently fa...
Make sure your private password phrase is only 15 characters long. If it's longer than 15 characters, just use the first 15 characters and see if it works.HTH,-Bhavik
Have you tried using "huntstop channel" command under the ephone-dn configuration?For dual-line ephone-dns, huntstop channel command keeps incoming calls from hunting to the second channel if the first channel is busy or does not answer. I hope this ...
