Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am facing this issue:Using Jabber MRA, everything is doing well: (CUCM 11.5 expressway: X8.9.1) - Service discovery ok - User authentication ok - Softphone registration ok - Hard phone control ok - Unity Connection message access ok - IM&Presen...
Hi,
I am facing this dilemma: I am deploying a 7500 users UC V11 Cluster on the customer virtualization infrastructure. The Servers are B200-M3 with 2.6Ghz CPU. that is ok. The only storage I can use is NFS-NAS. When deploying the OVA, thick disk pr...
Hi,
As SG3-to-SG3 fax calls at a speed up to 33,6kbps is supported on ISR G2 gateways since 15.1(1)T, is this also supported on VG310/320 gateways ?
If yes which protocol (H323, SIP, MGCP or SCCP) is recommended to achive such speed ?
Or is it bett...
Hi,I'm just designing a CUCM 11x cluster and have to reserve virtualization resources from my Customer. In Collab SRND 11x it is written (chapter 25) that a 2500 users VM needs: 2,500 users– 4 vCPU ??????– 6 GB vRAM– 80 GB vDiskIf I use "Collaborat...
Hi, I have to deploy Cisco Unified Communications on a multi site design.The particularity is that on each site data vlans are interconnected via a "Data IP WAN" while voice vlans are connected together through a separate "Voice IP WAN".I'll have wir...
Hi Maheer,
I think I am facing the same issue. First I Installed CUACA 10.5 on CUCM 11 and all was working well.
Then I upgraded CUACA to version 11 and now I have the issue that not all phones BLF are shown.
Depending on what search I do just after ...
Hi Jaime,
Thank you for your interest on my question. I openned a case near the PDI Helpdesk. So this is their point of view, quite close to yours:
- On NFS datastores that do not support Hardware Acceleration, only thin format is available.
- moving...
Hi Jonathan,I already have configured different régions to use g729 between remote sites but, however, you put me on the way telling that TRP is just a MTP.I fact I was thinking that the RTP flow between the 2 TRP's were re generated by the TRP's the...
