Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, since I`m not sure if it`s in the right category, I´m gonna post it here as well. we have just installed a new cisco wireless infrastructure. And actually it works fine. But our Prime (V2.2) is showing the following critical error for most of ...
Hello, since I`m not sure if it`s in the right category, I´m gonna post it here as well. We have just installed a new cisco wireless infrastructure. And actually it works fine. But our Prime (V2.2) is showing the following critical error for most of ...
Hello,we have just installed a new cisco wireless infrastructure. And actually it works fine. But our Prime (V2.2) is showing the following critical error for most of our Accesspoints, not for all:Access point 'OV-B-BM1-AP-03' associated with control...
Hello!We got a layer3 switched network, with one vlan for every switch, routed by a cat4006. Like that:Switch1: vlan 101, 172.16.101.0/24Switch2: vlan 102, 172.16.102.0/24Switch3: vlan 103, 172.16.103.0/24So can we put some ports on different switche...
Hello,we got a problem with our cat4006 coreswitch. The led on the supervisorengine is red, and several errors are appearing in the message log. Can anyone tell me what`s going on there?thanks in advance, Jan------------------------------------------...
Thank you. Good to know where exactly the Prime is getting the message from. I checked that and it looks just like in the example. One Antenna is disabled. But like i said, that`s ok. We dont need full feature set. What I need is a Prime not confusin...
I already created vlan 50 and added it to the trunks. I added the ip adress, but it doesnt work. Why the adress 192...?!? I guess you meant 172.16.50.1 ? But I tried both. How will that work?!! Let´s say the device on the vlan 50 port is a printer...
I have the same Problem with 2950 and 2924 Switches. A Solution would be very nice. I don`t have any Idea. The port status goes up when i switch on the printer, but ping doesn`t work. Any other static IP works.
