Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The BGP implementation on Meraki seems to be focused on using it as a route transport for a VPN overlay. I have a network which Meraki Internet edge devices (HA pair), which terminate a couple of PtP VPNs, but do not use AutoVPN. Today we have a pa...
We have an older S3260-M4 server. I would like to upgrade it with an M5 server module, but does anyone know if you can remove the array controller from the old M4 server and install it directly onto the M5 server module. We have about 128TB of stor...
I have a customer with an old 5508 Anchor controller which is used by a number of primary controllers. I built a new 5520 anchor controller but am trying to test it by bringing up a new mobility group on one of the primary controllers, that I plan t...
I have a 3504 HA pair of controllers which have 100 registered APs on them currently and they are licensed for 150 APs. They are a mix of 2800/3800 and a few 9120s. Recently we purchased a few more 9120s. They are all being added to the same Vlan...
I've been a CCIE for over 20 years and have connected a few dozen companies redundantly via BGP to the Internet over that time. It's been about 5 years since the last time I brought up redundant BGP routed ISP connections, and maybe I didn't do as m...
I upgraded all the drives in the server so they now show firmware 5705. I also upgraded the BIOS, BMC and CMC with the latest 4.2.3 bundle. However the drive we replaced is still showing as missing in the virtual drive info. In the Physical Drive ...
The other drives in the array are all running 5704. Do I need to upgrade all of them? or just the new drive and leave the rest of them on 5704? Also 5705 was not included until firmware bundle 4.2.3n. This an M4 server, and the latest supported ver...
I might be having a similar problem. We have an S3260-M4 chassis. The unit has a single server with dual boot SSDs. Internally we have two rows of 14 spinning disks, configured into two different RAID6 arrays (14 HDD each). One of the internal sp...
I will give that a shot. I did just notice something that might be the problem. The MAC that is being reported on the new Anchor for the local mobility group does not match the burned in MAC for the new Anchor WLC. You can't change that in the con...
I'm running into a problem with a Network Analysis Policy with FMC 7.0. The policy is the default balanced security & connectivity policy. No changes have been made to the Snort2 or Snort3 rules. When we enable IPS mode for the NAP, we have some r...
