Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All I have been working on existing WLC 2500 with a single individual interface with a handful wlan Ids.The interface is the management 192.168.120.0/25 192.168.121.10 the management interfaceI wanted to create an additional ID that would be dishi...
Multicast within a vlan not workingHi I have a 3850 switch with vlan 18 that I want to enable multicast on Off this witch I have a couple of 2960 stacks (3850)interface vlan 18 ip address 192.168.1.1 255.255.255.0ip pim sparse-mode!ip pim rp-address ...
Hi All
I currently have a router on a stick and I want to create a sub interface
int g0/0/0.49
encapsulation dot1q 49
ip address 192.168.1.1 255.255.255.0
!
on the switch this port connects to I have
switchport mode trunk
switchport trunk a...
Please see also the trunk config interface GigabitEthernet1/0/11description Wifi Controllerswitchport trunk native vlan 120switchport trunk allowed vlan 120,121 Many thanks
Here is new interface (Cisco Controller) >show interface detailed XXXXX-inXXXInterface Name................................... XXXXX-inXXXMAC Address...................................... 10:f3:11:a4:96:04IP Address......................................
@Rasika Nayanajith wrote:Current management interfaces is configured with vlan 0 (ie "untagged" on wlc side) then you have to make sure "sw trunk native vlan 120" is configured when you convert switchport to trunk mode. If you tagged management inter...
