Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hican anyone give me guidance on Multicast packet processing on 6509 with SUP720 ?How it processed, like software queue or Hardware queue ?What are the pors and cons for both ?
Hi I have a strange issue with Access switch & Cisco 6941 phone.On the switch site I am using cisco 4506 as a access switch & Phone type is 6941.The access port on the switch is had coded to 100Mbps Full duplex & Phone is on the default configuratio...
hi All,I am facing problem on the ASR 1001 for configuring keepalive on Gig interface.HW :ASR 1001IOS: asr1001-universalk9.03.04.04.S.151-3.S4.binInterface : GigMessage is " Keepalive not supported "
Hi All,I have configured below point to point link with FR switch in GNS 3.below is the configuration for the senario.R1#sh run int serial 0/0Building configuration...Current configuration : 144 bytes!interface Serial0/0 no ip address encapsulation f...
Hi Akash, Thank you for your input, this is what i have got from Cisco TAC.My point here is that when I am having this kind of configuration, whats its implication on my device ? will it trigger any issue with memory on my device ?
Hi Joseph, Thank you for the answer, however i am seeing one unwanted logs on my device its 6509E device with SUP720."MLSM[2]: mlsm_process_pending_event ERROR in processing" Could this be the cause for Hardware queue over utilization ?
Hi Alain,I did no shut but still the result is the sameR2#sh frame-relay mapSerial0/0.201 (down): point-to-point dlci, dlci 201(0xC9,0x3090), broadcast status deleted RegardsAmol
