Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to start IPSEC tunnel between 2 location. My location use Router 2911, and second location, uses SBC 6300. I do not have any experince with SBC 6300. For now, we did not get Phase 1 UP.
VPN_Gand#sh crypto isakmp saIPv4 Crypto ISAK...
Hello friends
My company has got ASA 5510 without CF. I inserted a few CF but without any success.I tried to use CF from my ASA 5505, too. I tried to use format, and fsck, but everything was the same. Can I use the same image from ASA 5505 on ASA...
Hello to everyone
How are you :). I got some task, I must configure IPSec Site to Site tunnel, between ASA (7.x.x) and Cisco Router 2911 (IOS 15.x). I must configure rouer 2911, with NAT (overload),
We planeed our traffic to NAT in 10.253.191.229,...
Hi, how are you :). I have one question, about router Cisco 2911, and Juniper Netscreen 25, ver 5.4. I must start IP Sec tunnel between these two devices. I must use agressive mode, I saw this in configuration document. Question, how can I use agres...
Hi, we have a problem, with ASA CX 5512, anyconnect users can use webmail normaly, but, outside users, who came from outside interface (without anyconnect) cannot get webmail page, only got error 403 with some message about ssl problem, when we turn ...
I do not understand this lines... why two lines for the same peer ? One active but with 0 id_Conn, and secound, Active, but deleted....VPN_Gand#sh crypto isakmp saIPv4 Crypto ISAKMP SAdst src state conn-id status217.x...
Hm, now I think ASA has problem with CF reader. This is only normal reason. Can I format CF on Cisco Router 2801. Does both of the Cisco devices use the same file system?
