Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About Felipe Ramos
Stats
Member since
06-30-2012
23
Posts
40
Helpful
1
Solution
07-23-2015
04:42 PM
I was facing the same issue here in Brazil, took a lot of time to me to figure it out. All extensions are in the format \+55XXXXXXXXXX (55=Brazil, XX=Two digits state code, XXXXXXXX=local number). The number were overlapping with the internation route pattern \+!. I replaced \+! with two other partners: 1. \+[^5]! 2. \+5[^5]! If you have a large cluster in different countries, you may need to create exceptions for each country code. HTH Felipe
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
07-23-2015
04:37 PM
07-23-2015
04:37 PM
Hi Everyone, I was facing the same issue here in Brazil, took a lot of time to me to figure it out. All extensions are in the format \+55XXXXXXXXXX (55=Brazil, XX=Two digits state code, XXXXXXXX=local number). The number were overlapping with the internation route pattern \+!. I replaced \+! with two other partners: 1. \+[^5]! 2. \+5[^5]! If you have a large cluster in different countries, you may need to create exceptions for each country code. HTH Felipe
... View more
Created by
Felipe Ramos
in Contact Center
in Contact Center
08-12-2013
01:54 PM
08-12-2013
01:54 PM
Can you send me this link? How could the UCCX knows the difference from TDM to another site of yours if everything is SIP. SIP is the same for everything. Right?
... View more
Created by
Felipe Ramos
in Contact Center
in Contact Center
08-12-2013
12:37 PM
08-12-2013
12:37 PM
I'm am with the same f*** problem. Can somone give a hand on this?
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
07-05-2013
10:16 AM
07-05-2013
10:16 AM
Guys, Can someone help? I'm trying to connect to IPC alliance over a E1 Link. The configuration is below. I'm receiveing this message when debuging ISDN Q921: *Jul 5 17:38:59.735: ISDN Se0/1/1:15 Q921: L2_EstablishDataLink: sending SABME *Jul 5 17:38:59.735: ISDN Se0/1/0:15 Q921: Net TX -> SABMEp sapi=0 tei=0 My ISDN status is: BTG-COL-VG#show isdn status Global ISDN Switchtype = primary-qsig ISDN Serial0/1/0:15 interface ******* Network side configuration ******* dsl 0, interface ISDN Switchtype = primary-qsig **** Master side configuration **** Layer 1 Status: ACTIVE Layer 2 Status: TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED Layer 3 Status: 0 Active Layer 3 Call(s) Active dsl 0 CCBs = 0 The Free Channel Mask: 0xFFFF7FFF Number of L2 Discards = 0, L2 Session ID = 98 ISDN Serial0/1/1:15 interface ******* Network side configuration ******* dsl 1, interface ISDN Switchtype = primary-qsig **** Master side configuration **** Layer 1 Status: ACTIVE Layer 2 Status: TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED Layer 3 Status: 0 Active Layer 3 Call(s) Active dsl 1 CCBs = 0 The Free Channel Mask: 0xFFFF7FFF Number of L2 Discards = 0, L2 Session ID = 98 Total Allocated ISDN CCBs = 0 Part of the show run: BTG-COL-VG#show run Building configuration... Current configuration : 3515 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname BTG-COL-VG ! boot-start-marker boot-end-marker ! logging buffered 100000 enable secret 5 $1$86J6$M9vu8saSudfsVIycg25tZ0 ! no aaa new-model network-clock-participate wic 1 ip cef ! ! ! ! no ip domain lookup ! multilink bundle-name authenticated ! isdn switch-type primary-qsig ! voice-card 0 ! ! ! voice service voip address-hiding allow-connections sip to sip redirect ip2ip fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711alaw sip bind control source-interface FastEthernet0/1 bind media source-interface FastEthernet0/1 ! ! voice class codec 1 codec preference 1 g711alaw codec preference 2 g711ulaw codec preference 3 g722-48 codec preference 4 g722-56 codec preference 5 g722-64 codec preference 6 g723ar53 codec preference 7 g723ar63 codec preference 8 g723r53 codec preference 9 g723r63 codec preference 10 g726r16 codec preference 11 g726r24 codec preference 12 g726r32 codec preference 13 g728 codec preference 14 g729br8 codec preference 15 g729r8 codec preference 16 gsmamr-nb codec preference 17 gsmefr codec preference 18 gsmfr codec preference 19 ilbc codec preference 20 clear-channel ! voice translation-rule 1 rule 1 /^756/ // ! voice translation-profile incoming_pstn translate called 1 ! controller E1 0/1/0 clock source internal pri-group timeslots 1-31 ! controller E1 0/1/1 clock source internal pri-group timeslots 1-31 ! interface FastEthernet0/0 description LAN ip address 10.26.33.20 255.255.255.0 speed 100 full-duplex ! interface FastEthernet0/1 ip address 192.168.150.2 255.255.255.248 duplex auto speed auto ! interface Serial0/1/0:15 no ip address encapsulation hdlc no logging event link-status isdn switch-type primary-qsig isdn timer T310 300000 isdn protocol-emulate network isdn incoming-voice voice isdn supp-service name calling no cdp enable ! interface Serial0/1/1:15 no ip address encapsulation hdlc no logging event link-status isdn switch-type primary-qsig isdn timer T310 300000 isdn protocol-emulate network isdn incoming-voice voice isdn supp-service name calling no cdp enable ! ip route 0.0.0.0 0.0.0.0 10.26.33.1 ip route 10.7.17.226 255.255.255.255 192.168.150.1 ! ! ip http server no ip http secure-server ! disable-eadi ! control-plane ! voice-port 0/1/0:15 cptone CO ! voice-port 0/1/1:15 cptone CO
... View more
Labels:
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
05-02-2013
03:41 PM
05-02-2013
03:41 PM
Unbeliveable! It is working! What do you think happened?? I dont even know how to explain this here, make no sense...
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
05-02-2013
03:28 PM
05-02-2013
03:28 PM
Yeah! It worked, out of the RG/RL it is working! Do you have any idea of what is happening?
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
05-02-2013
02:47 PM
05-02-2013
02:47 PM
aokanlawon Thanks very much for your help. No, there is no firewall or network conection issue. Another important thing is, i was able to call NY from BR. Cheers, Felipe braga
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
05-02-2013
01:57 PM
05-02-2013
01:57 PM
##1275 9994 From NY to Brazil ##1269 2000 From Brazil to NY
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
05-02-2013
01:24 PM
05-02-2013
01:24 PM
aokanlawon, In attach. You will see i changed some address and number in the olders replays. I tought it would be more secure, but thinking straight this dont matter at all. Thanks for your answer.
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
05-02-2013
12:31 PM
05-02-2013
12:31 PM
Thanks for your answer! I guess that is the point, but i don't know what am i missing. I cant see h225 messages from the NY cluster using the RTMT on NY. Is like that cluster was not even trying to make the call. I tried to restart the trunk and the RL both clusters. I'm with a open case on Cisco (625563973) too. I'm starting to belive this is a bug or pig head buried over my data center....
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
04-28-2013
06:58 PM
04-28-2013
06:58 PM
Hey, Thanks all for the answers. So... Checked again. I run DNA on both cluster for in and out calls. Everthing is perfectly on DNA. The IP address used for the cluster in NY is one server in Brazil that is in the CallManager Group in the Device Pool of this cluster. The same for Brazil to NY. I tried to add all IP address from both cluster on each other trunks and select the option "Run on all cluster" on both trunks. The same. When i run the SDI log on CUCM at Brazil i can see h323 info been exchanged. When i do the same in NY i can´t. As i i´m receiving this error 41, who in ISDN means no phisical connection or something like that, i´m guessing there is a service stucked. I will try to reboot the server or restart the CallManager service, but i was not able to get a maintance windows yet.
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
04-25-2013
08:59 AM
04-25-2013
08:59 AM
Hey Guys, First, thanks very much for your help. Answering your questions: Calling number? 10692000 Called number? 10219994 Time of call? 17:09:52.012 (Brazil time) What do you get when you call from NY to Brazil? Just fastbusy I ran the DNA on this and the call is being routed correctly. Not only from NY perspective but from Brazil too. Do you have any debug that i can run on this?
... View more
Created by
Felipe Ramos
in IP Telephony and Phones
in IP Telephony and Phones
04-24-2013
02:55 PM
04-24-2013
02:55 PM
Guys, need backup! I'm setting up a ICT between two CallManagers Clusters (Brazil and NY). The calls are working from Brazil cluster to NY Cluster but not the reverse. I'm attached the logs from NY Cluster! Cheers, Felipe
... View more
Labels:
ONE WAY VOICE ISSUE H.323 Gateway
in Other Collaboration Subjects
09-04-2012
12:10 PM
09-04-2012
12:10 PM
Can you send the output of "show call active voice brief" during the call? Regards
... View more
07-23-2015
I was facing the same issue here in Brazil, took a lot of time to me to
figure it out. All extension...
07-23-2015
Hi Everyone,I was facing the same issue here in Brazil, took a lot of
time to me to figure it out. A...
Created by
Felipe Ramos
in TelePresence and Video Infrastructure
08-26-2013
08-26-2013
Hello Everyone,I'm having problems connecting video over a cisco voice
gateway. I attached the debug...
08-12-2013
Can you send me this link? How could the UCCX knows the difference from
TDM to another site of yours...
07-05-2013
Guys,Can someone help?I'm trying to connect to IPC alliance over a E1
Link. The configuration is bel...
Created by
Felipe Ramos
in TelePresence and Video Infrastructure
07-03-2013
07-03-2013
Hello Guys,I need help integrating Webex on premisses with Polycom
endpoints and MCU. Did someone tr...
Created by
Felipe Ramos
in IP Telephony and Phones
05-02-2013
05-02-2013
Unbeliveable! It is working!What do you think happened??I dont even know
how to explain this here, m...
Created by
Felipe Ramos
in IP Telephony and Phones
05-02-2013
05-02-2013
Yeah! It worked, out of the RG/RL it is working!Do you have any idea of
what is happening?
Created by
Felipe Ramos
in IP Telephony and Phones
05-02-2013
05-02-2013
aokanlawonThanks very much for your help.No, there is no firewall or
network conection issue. Anothe...
Created by
Felipe Ramos
in IP Telephony and Phones
05-02-2013
05-02-2013
##1275 9994 From NY to Brazil ##1269 2000 From Brazil to NY
Created by
Felipe Ramos
in IP Telephony and Phones
05-02-2013
05-02-2013
aokanlawon,In attach. You will see i changed some address and number in
the olders replays. I tought...
Created by
Felipe Ramos
in IP Telephony and Phones
05-02-2013
05-02-2013
Thanks for your answer! I guess that is the point, but i don't know what
am i missing. I cant see h2...
Created by
Felipe Ramos
in IP Telephony and Phones
04-28-2013
04-28-2013
Hey,Thanks all for the answers.So... Checked again. I run DNA on both
cluster for in and out calls. ...
Created by
Felipe Ramos
in IP Telephony and Phones
04-25-2013
04-25-2013
Hey Guys,First, thanks very much for your help.Answering your
questions:Calling number? 10692000Call...
Public Statistics
| Date Registered | 06-30-2012 03:55 AM |
| Date Last Visited | 08-18-2017 04:03 AM |
| Total Messages Posted | 23 |
| Total Helpful Votes Received | 40 |
.jpg "VIP Mentor"){kind=icon}
