Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, guysHow are you?Just one question, im wondering if you have any Ciscos recommendation or Case Study when talks about the limit of numbers of dial-peers, i mean, what is the maximum limit of dial-peers that Cisco recommends?Also, is there any reco...
Hi everyone!I have this question, even could be a little dummie.I have a LAN environment, for example on this interface on R1:hostname R1!int fa0/0ip address 192.168.1.1 255.255.255.0!And there is another router R2 connected to the same LAN segment, ...
Hi!Anyone knows a workaround for changing the tacacs+ port on the routers which are gonna be controlled by tacacs, if the keyword "port" is not allowed on the "tacacs-server host x.x.x.x <port>" for the version running? any ideas beside changing the ...
Hi everyone!One of my costumers is connected to my Internet network (im an isp), the costumer is using dynamic nat, and on the other end, there is a PPTP server (on a hosted environment), the costumer complains that sometimes can´t connect throught t...
Hi guys, having a 7513 runing MPLS VPN, wiht QoS, the router started since 1 week ago with this log:14w1d: %SYS-2-QCOUNT: Bad deqeueue 63C85E28 count 1-Process= "<interrupt level>", ipl= 1-Traceback= 6025FEC0 60260660 60261274 60261380There is no aff...
Hello, gallag!It seems is a "bad practice" it seems somebody has been attaching a EMPTY map-class within a subinterface; and after that is creating the map-class..Thank you very much for your very helpful answer!!!
Thanks for the answer!!Cisco recommend us to make these Workarouds:1.- Reset the VIP (we already did it but the error is appearing again)2.- Microcode Reload...we haven´t done that because of the affectation (costumers)...Gallagh i would like to know...
Hi, gallagh, thanks for your answer, this is the sh ver of this equipment:Router#sh verCisco Internetwork Operating System Software IOS (tm) RSP Software (RSP-JSV-M), Version 12.2(17a), RELEASE SOFTWARE (fc1)Copyright (c) 1986-2003 by cisco Systems, ...
Hi, thanks for the answer, yes , the policy is supposed to be working:RPM#sh policy-map interface multilink 2001 Multilink2001 Service-policy output: QOS Class-map: VOZ (match-any) 773079 packets, 44114342 bytes 30 second offered rate ...
