Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to upgrade my CRS server with nuance 3.0 to nuance 4.0? I'm not sure this is possible since beginning with Vocalizer 4.0 and CRS 4.0 the products are purchased seperately and no longer bundled..Thanks
I am trying to forward an IP phone to a long distance number. The problem is that an access code is required after dialing the number. Is there any way to insert a pause after the dial string and then pulse the code? Thanks
I am trying to use LFI over a GRE tunnel will this work? When I do "show ppp multilink" it shows inactive. Am I doing something wrong? Here is the relevant config...ThanksJim!interface Tunnel26 description Remote A ip unnumbered Loopback0 qos pre-cla...
The users are getting a lot of blank voice mails. Probably 20% everyday are blank. I am running 2.46 with CM 3.1.3a and exchjange 5.5. Any suggestions would be greatly appreciated. Thanks<br><br>Jim <br><br>
CSCef60476On a FWSM that has several interfaces with the same security level and IP phones in a different VLan than the CallManager server, the phones register but when they go offhook they do not get a dial tone and they reset. That is in 2.3(1) FWS...
Only the Cisco ACU with the EAP-FAST supplicant can be configured for this. There is a purpose revision to the Cisco Aironet extensions(version 3) that is suppose to support EAP-FAST. But unfortunately there is no release date for this at this time...
Sara, Here is a sample config that works.......Jimset vlan 1 name default type ethernet mtu 1500 said 100001 state activeset vlan 2 name VLAN2 type ethernet mtu 1500 said 100002 state activeset vlan 3 name VLAN3 type ethernet mtu 1500 said 1...
Sara, I am using that module. We have the VWIC (MFT) installed and use for WAN connectivity. I had a bit of trouble getting it to work myself. You do know that the L3 part only supports (5 or 6 forgot) VLANS. I pruned all but the needed ones...
Thanks, not sure if that helps. We have two Option 81's and they connect to a 2600 and 7200 both connections configured as a PRI. One side Master one side Slave. "D" channel needed for mwi, etc.. I didn't see anyhting specifically mentioning ISDN PRI...
