Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.
I need to upgrade an ASR 1004 RP2 that actually is using version 16.03 to version 17.xx
I have a question if this upgrade can be done directly or there is an upgrade path and also about the license, after the upgrade I need to reinsta...
I have created a tunnel-te from xrv16 to csr3, the tunnel is up and getting Pop label to csr3 that's ok.From xrv16 I have learned the route to xrv17 over the tunnel, but checking the Label it's unlabbled as well.I believe the route from xrv16 to xrv1...
Hi guys.
This is the first time I am using this switch for qinq. The issue is because I need to encapsulate lacp over the tunnel but on the interface customer side, I have no command for that. The nx-os is able to encapsulate stp, vtp, but I didn't s...
Hi guys!
I'm migrating a L2TP/vpdn connection from Cisco Router 7200 IOS to ASR1006 IOS-XE 15.2(4)S3 and everything appears to be right, the authentication is passing ok, the end-point takes an ip address but the major issue, the icmp between end-po...
Hi guys!
Today I was almost crazy because I was changing one Policy (removing a condition in and replacing for a condition not in) and the ACS was freezing, after some minutes it gives a message that I clicked many times and back again. After that al...
Dear MHM I really agree with you, but the issue was the routes behind the tunnel. So, if you add another Router after the R3 you will see same problem, it means if you add one more Router R30 with the loopback 30.30.30.30/32 probably it will come on ...
Hi Harold Ritter, thank you for your time.
After adding the following configuration from now on I've label end-to-end.
xrv16mpls ldp interface tunnel-te10 address-family ipv4mpls ldp neighbor 10.10.10.3:0 password disable
CSR3mpls ldp neighbor 10.10....
Oh yeah.
After many years the solution is the same. I needed to NAT only the first octet and the tip above me worked perfect.
Be honest, I never payed attention about the option "network" under NAT config.
Thank you.
